Hello!
Hope all is well with you!
We went from below zero to 55 degrees in a week. I can hear the melting snow and am watching over my sump pump because I saw a pipe broken outside. I MacGyvered it as best I could until I get the correct parts. Fingers crossed!
I spent the weekend stitching these eggs and dreamt of Spring. These are from Spellbinder's 3D Egg dies by Sandi MacIver. There are two sizes. The smaller one is in the middle. They make sweet, un-breakable decorations and are addicting to sew! I love super-quick projects! I added decorations with dies in the set as well as pulling from some other sets. Any die will cut the felt.
I die-cut an "egg-stra" set of pieces so I can make a brief YouTube tutorial very soon. Please "hop" over to my @Darbycreek channel and set the notification bell so you won't miss it!
Please note these are made with a wool blend felt you can get from several shops (I'll link them below for you!). The felt diecuts just like paper! I use the same setting on my machine with no problem. It does however, make a bit of a mess with all the little holes in the dies, but the Spellbinder's Tool 'n One works great to get the felt that gets stuck. You can also bounce the dies off the table to get them out. I flicked them on the side of my trash can too.
I've got to run and check on the water situation again, but will be back again very soon! Happy early Valentine's Day!
Here are the supplies I used:
No comments:
Post a Comment
I love hearing from you! LMK by email if you have problems commenting or following. I am also grateful if you would kindly refer a friend or two! Thanks!